Finlux 50F8090-T User Manual download pdf (Page 8)

English - 7 -

Inserting the Batteries into the Remote Control

1. Lift the cover on the back of the remote upward

gently.

2. Install two AAA batteries. Make sure to match

the + and - ends of the batteries in the battery

compartment (observe the correct polarity).

3. Replace the cover.

Connect Power & Antenna

IMPORTANT: The TV set is designed to operate on

220-240V AC, 50 Hz socket. After unpacking, allow the

TV set to reach the ambient room temperature before

you connect the set to the mains. Plug the aerial cable

into the ANT socket on your TV.

HDMI 1

HDMI 2

SPDIF

Coax.OUT

HDMI 1

HDMI 2

SPDIF

Coax.OUT

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz.

Then the standby LED lights up.

To switch on the TV from standby mode either:

Press the “ ” button, P+ / P- or a numeric button on

the remote control.

Press the control switch located on the left side of the

TV. The TV will then switch on.

To Switch the TV Off

Press the “ ” button on the remote control or press

and hold the control switch on the TV until the TV

shuts down, so the TV will switch to standby mode.

To power down the TV completely, unplug the power

cord from the mains socket.

Note: When the TV is switched to standby mode, the standby

LED can blink to indicate that features such as Standby

Search, Over Air Download or Timer is active. The LED can

also blink when you switch on the TV from standby mode.

First Time Installation

When turned on for the rst time, the “language

selection” menu appears. The message “Welcome

please select your language!” is displayed and all

language options are listed alphabetically.

Press the “ ” or “ ” button to highlight the required

language, press OK button to select. “First Time

Installation” appears. Use “ ” or “ ” button to set the

required country, and press “ ” button to select Search

Type. Use “ ” or “ ” to set the desired search type.

Available search types are digital and analog, digital only

and analog only. When set, press “ ” to select Teletext

Language. Use “ ” or “ ” button to set the “Teletext

Language” and select “Scan Encrypted” using “ ” or “

” button. You can set Scan Encrypted as Yes if you

want to scan coded stations.

Press OK button on the remote control to continue and the

following message will be displayed on the screen.

You can activate Store mode option by using “

” or “ ” button. If Store Mode is selected, Store

mode option will be available in other settings menu

and your TV’s features will be illustrated on the

top of the screen. A confirmation screen will be

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 34 35

Comments to this Manuals

No comments

Finlux 50F8090-T User Manual Page 8

Comments to this Manuals

Related products and manuals for LCD TVs Finlux 50F8090-T